Tel: 86-21-54700210
Mobile: 86-13851087033
Products Name: Precision Milling Tool Grinder
Category:Tool Grinders
Item Number: 0231
Products Model: V-66
View: 75
Tel:86-13851087033
E-mail: vulmac@163.com
Specification:
mm | inch | ||
End mill capacity | dia. Of shank | 50mm | 2 |
dia. Of edge | 225mm | 9 | |
length | 250mm | 10 | |
Swing over table | 245mm | 9-3/4 | |
Longitudinal travel (X axis) | 150mm | 6 | |
Cross travel of table (Y Axis) | 75mm | 3 | |
Max. Wheel | 125 x 50 x 32mm | 5 x 2 x 1-1/4 | |
Tilt adjustment for wheelhead | +35° -10° | ||
Air bearing swivel | 360° | ||
Air bearing stroke | 250mm | 10 | |
Table infeed graduation | 0.02mm | 0.001 | |
Air bearing graduation | 6.3MPa | ||
Pipe joint diameter | Z/4 1 | ||
Collet fit for spindle | 5C | ||
Parallelism between two tables | 0.01/100mm, 0.01/100 | ||
Motor speed: 2, 800rpm | 3, 450/2, 580rpm | ||
Voltage | 220V ,1 phase | ||
Power | 0.75kw | 1HP | |
Frequency | 50Hz |
Radius Grinding Attachment:
Install T-shaped slot width | 12.7mm |
Spring chuck | 5C |
The minimum feed unit | 0.012mm |
Maximum griding arc radius | 75mm |
Equal dividing | 30degree |
Parallelish of work hole to base | 0.02/60mm |
Radial run out of work hole center line(60mm for hole) | 0.015mm |
Air Bearing Grinding Attachment:
Max. Stroke of air bearing sleeve | 220mm |
Collect for work table | 5C |
T-shaped slot width for table | 12.7mm |
Air consumption | >0.63Mpa |
Tracheal joints | 6mm |
Turning angle | 360degree |
Parallelism of workhole center line to abse surface | 0.015mm |
Radius run out of workhole center line(60mm for hole) | 0.015mm |
Copyright @ vulmac.com
Tel: 86-21-54700210 Mobile: 86-13851087033 (Whatsapp, WeChat)
E-mail: vulmac@163.com
Add: Room 118, Building 20, No. 1-42, Lane 83, Hongxiang Road North, Lin'gang Special Area of China (Shanghai) Pilot Free Trade Zone, Shanghai, China